X thermostat™ TS-500
Description
The TS 500 is an intuitive fully programmable semi-recessed thermostat. This wall mounted, floor/ceiling and room sensing unit features a backlit touch-screen interface.
The TS 500 can be configured to sense floor or room temperature only. In the case of floor sensing only, the unit may be mounted on a wall or hidden in a cupboard or vanity unit.
- Programmable semi-recessed thermostat for controlling heating systems.
- Customisable 7-day timer programmable down to the minute.
- Floor or room sensing (or both)
- ON / OFF Main switch (on screen)
- Relay 16A
- Mounted horizontally
- Description
Description
Technical Characteristics
| Sensing Type | Air / Floor / Air-Floor |
| Mounting | Surface mounted |
| Measuring accuracy | 0.1°C |
| Operating temperature | 0ºC – 50°C |
| Setting temperature range | 5ºC – 35°C |
| Electrical protection | Class II – IP21 |
| Main switch | Two poles 16A |
| Power supply | 230Vac +/- 10% 50Hz |
| Output | Relay 16A 250Vac resistive load |
| Type of external sensor | NTC – 15 kOhms at 25°C |
Related Products
-
Read moreQuick ViewXmat™ MG-150
Thin Heating Mats (c/w Single Cold Tail)
Devex Systems’ Xmat™ MG-150 electric floor heating mat is only 3.5mm thick and uses a twin conducting heating cable for ease of installation, with very low EMF. It can be easily installed directly over concrete, fibre cement sheet or F-board insulation and into thin adhe- sive beds or floor levelling compounds. This means there is minimal increase in the floor height. The system is best utilised on a “time of use” tariff as it is quick to come to the desired temperature. The X mat is 500mm wide and come with a single 3m cold tail. The cables comply with IEC60800:2009.
We recommend the use of F-Board Insulation with electric floor heat- ing to improve warm up times and reduce running costs.
- 20 year warranty
- Output power based on 230 volts
- Operating Temperature Range: -30°C to +80°C
- Minimum Temperature during Installation: -5°C
- Self adhesive mesh sticks to any clean substrate
Read moreQuick View -
Read moreQuick ViewX thermostat™ TS-100
Description
- Electronic surface-mounted thermostat with setback mode.
- Switch to select comfort, setback or external timer.
- External timer to signal comfort or setback.
- The ability to regulate either the floor temperature, room temperature, or a combination of both.
- ON /OFF switch.
- Relay 16A.
Read moreQuick View -
Read moreQuick ViewX thermostat™ TS-300
Description
- Programmable semi-recessed thermostat for controlling heating systems.
- Customisable 7 day timer programmable down to the minute.
- Floor or room sensing
- ON /OFF Main switch.
- Relay 16A.
- Can be mounted vertically or horizontally.
Read moreQuick View -
Read moreQuick ViewXcable™ CK-17
In Screed Heating Cable (c/w Single Cold Tail)
Devex Systems’ Xcable™ CK-17 electric floor heating cable uses a twin conducting heating cable for ease of installation. This flexible cable made with fluoro-polymer and durable PVC outer sheath can be easily installed directly on a structural slab, fibre cement sheet, or F-Board insulation and into 20-25mm screed bed. This system best operates on a “time of use” tariff as it is quick to come to the desired temperature. The X cable is rated at 17 watts per meter and comes with a 3m single cold tail. The cables comply with IEC60800:2009.
We recommend the use of F-Board Insulation with electric floor heating to improve warm up times and reduce running costs.
- 20 year warranty
- Output power based on 230 volts
- Maximum Operating Temperature: +70°C
Read moreQuick View -
Read moreQuick ViewX thermostat™ TS-400
Description
- Din-rail thermostat suitable to be mounted in the switchboard.
- Compatible with all home-automation systems such as C-Bus.
- Recommended for systems connected to Off-Peak power supply.
- Floor (external sensor)
- Relay 16A 250Vac resistive load (AC1)
Read moreQuick View -
Read moreQuick View
Xcable™ CT-30
In Slab Electric Heating Cable (c/w Single Cold Tail)
Devex Systems’ Xcable™ CT-30 electric floor heating cable can be installed into concrete slab under a wide range of floor coverings. The CT-30 has a very low EMF and its single cold tail makes it easy to install. The CT-30 is most suited to be connected to an “Off-Peak” or “Time of Use” tariff as an in-slab storage heating system. This cable’s steel armor and multiple layers of conductor insulation make it extremely durable and also able to be used for snow melting. The cable is rated to 30 watts per meter and it comes with a single 3m cold tail.
We recommend the use of Extruded Polystyrene (XPS) Insulation with electric in-slab heating to improve warm up times and reduce running costs.
- 20 year warranty
- Output power based on 230 volts
- Maximum Operating Temperature: +70°C
Read moreQuick View -
Read moreQuick ViewX thermostat™ TS-600
Description
The TS 600 is an intuitive fully programmable semi-recessed thermostat. This semi-recessed, floor/ceiling and room sensing unit features a touch-screen interface and can be controlled from a smartphone using the Devex System app.
- Programmable semi-recessed thermostat for controlling heating systems.
- Customisable 7-day timer programmable down to the minute.
- Floor or room sensing (or both)
- ON / OFF Main switch (on screen)
- Relay 16A
- Mounted horizontally
- Wifi
Read moreQuick View -
Read moreQuick View
X thermostat™ TS-200
Description
- Electronic semi-recessed thermostat specially designed to control electric floor heating.
- Setback for night reduction (-4°C) via external timer.
- Possibility to regulate either the floor temperature, room temperature or a combination of both
- ON /OFF switch.
- Relay 16A.
- Can be mounted horizontally or vertically.
Read moreQuick View
